254534 – Pepperl+Fuchs

STOCK: 0.00 unidade(s)
VBG-ENX-K20-DMD-EV AS-Interface Gateway V3.0 “P+F”

Connection to Ethernet Modbus TCP/IP
2 AS-Interface networks
Easy commissioning and fault diagnosis via LEDs and graphic display
Dublicate addressing detection
Integrated data decoupling
Integrated switch allows line topology
Integrated webserver
Earth fault detection
AS-Interface noise detection
Ethernet diagnostic interface
DLR technology supports ring topology

PLC-Functionality activateable
Duplicate address detection from AS-Interface slaves
Earth fault detection integrated
EMC monitoring integrated
Diagnostics function Extended function via display
Data decoupling integrated
UL File Number E223772 only from low voltage, limited energy source (SELV or PELV) or listed Class 2 source
Indicators/operating means
Display Illuminated graphical LC display for addressing and error messages
LED AS-i ACTIVE AS-Interface operation normal; LED green
LED CONFIG ERR configuration error; LED red
LED PRG ENABLE autom. programming; LED green
LED POWER voltage ON; LED green
LED PRJ MODE projecting mode active; LED yellow
LED SER ACTIVE ethernet active; LED green
LED U AS-i AS-Interface voltage; LED green
Button 4
Switch SET Selection and setting of a slave address
OK button Mode selection traditional-graphical/confirmation
Button MODE Mode selection PRJ-operation/save configuration/cursor
ESC button Mode selection traditional-graphical/cancel
Electrical specifications
Insulation voltage = 500 V
Rated operating voltage from AS-Interface 30 V DC
Rated operating current = 250 mA PELV
Power supply max. 4 A per AS-Interface circuit
Interface 1
Interface type 2 x RJ-45
Protocol EtherNet/IP + MODBUS TCP/IP acc. to IEEE 802.3
supports device level ring protocol DLR
Transfer rate 10 MBit/s / 100 MBit/s , Automatic baud rate detection
Interface 2
Interface type RS 232, serial
Diagnostic Interface
Transfer rate 19,2 kBit/s
Interface 3
Interface type Chip card slot
Connection
Ethernet RJ-45
AS-Interface spring terminals, removable
Directive conformity
Electromagnetic compatibility
Directive 2014/30/EU EN 62026-2:2013 EN 61000-6-2:2005, EN 61000-6-4:2007
Standard conformity
Electromagnetic compatibility EN 61000-6-2:2005, EN 61000-6-4:2007
Degree of protection EN 60529:2000
AS-Interface EN 62026-2:2013
Shock resistance EN 61131-2:2004
Approvals and certificates
UL approval An isolated source with a secondary open circuit voltage of = 30 VDC with a 3 A maximum over current protection. Over current protection is not required when a Class 2 source is employed.
UL mark does not provide UL certification for any functional safety rating or aspects of the device.
Ambient conditions
Ambient temperature 0 … 55 °C (32 … 131 °F)
Storage temperature -25 … 85 °C (-13 … 185 °F)
Mechanical specifications
Degree of protection IP20
Material
Housing Stainless steel
Mass 500 g
Construction type Low profile housing , Stainless steel
Classifications
System Classcode
ECLASS 11.0 27242607
ECLASS 10.0.1 27242607
ECLASS 9.0 27242607
ECLASS 8.0 27242607
ECLASS 5.1 27242607
ETIM 8.0 EC001603
ETIM 7.0 EC001603
ETIM 6.0 EC001603
ETIM 5.0 EC001603
UNSPSC 12.1 39121535