2964283 – Phoenix Contact

STOCK: 0.00 unidade(s)
DEK-OE- 24DC/ 24DC/100KHZ SolidStateRelay “Phoenix Contact”

29 64 28 3
Input solid-state relay, transmission frequency: 100 kHz, with LED and protective circuit in input and output circuits, input: 24 V DC, output: 4 – 30 V DC/50 mA
Use of EB 80-DIK… bridges in the DEK terminal blocks: Absorption of humidity from the ambient air as well as an unfavorable tolerance between a larger number of DEK terminal blocks and the EB 80-DIK… bridge may cause (minor) expansion of the DEK housing. When the EB 80-DIK… bridges are used, therefore, it is recommended that these be disconnected after about 10 to 12 DEK terminal blocks and a wire bridge to the next DEK terminal block be inserted in their place
Product type Solid-state relay module
Product family DEK
Application 100 kHz input optocoupler
Operating mode 100% operating factor
Insulation Basic insulation
Insulation Basic insulation
Overvoltage category II
Pollution degree 2
Maximum power dissipation for nominal condition 3 mW
Test voltage (Input/output) 2.5 kV AC (Input/output)
Nominal input voltage UN 24 V DC
Input voltage range in reference to UN 0.8 … 1.2
Input voltage range 19.2 V DC … 28.8 V DC
Switching threshold “0” signal in reference to UN = 0.4
Switching threshold “1” signal in reference to UN = 0.8
Typical input current at UN 6 mA
Typical response time 1.5 µs
Typical turn-off time 2 µs
Operating voltage display Yellow LED
Protective circuit Reverse polarity protection; Polarity protection diode
Surge protection
Transmission frequency 100 kHz
Contact type 1 N/O contact
Design of digital output electronic
Output voltage range 4 V DC … 30 V DC
Limiting continuous current 50 mA
Quiescent current 4.3 mA
Voltage drop at max. limiting continuous current = 0.5 V DC
Output circuit 3-conductor, ground-referenced
Protective circuit Surge protection; Suppressor diode
Connection method Screw connection
Stripping length 8 mm
Screw thread M3
Conductor cross section rigid 0.2 mm² … 2.5 mm²
Conductor cross section flexible 0.2 mm² … 2.5 mm²
Conductor cross section AWG 24 … 14
Tightening torque 0.5 Nm
Width 6.2 mm
Height 80 mm
Depth 56 mm
Ambient temperature (operation) -20 °C … 60 °C
Ambient temperature (storage/transport) -20 °C … 70 °C
Standards/regulations IEC 60947-5-1
Mounting type DIN rail mounting
Assembly instructions in rows with zero spacing
Mounting position any
ECLASS-11.0 27371604
ETIM
ETIM 8.0 EC001504
UNSPSC
UNSPSC 21.0 39122300
REACh SVHC Lead 7439-92-1
Hexahydromethylphthalic anhydride
China RoHS Environmentally Friendly Use Period = 50 years
For information on hazardous substances, refer to the manufacturer’s declaration available under “Downloads”